Where is the MAP Sensor located.? on 1996 Buick LeSabre

Are there any precautions in replacing it? The actual removal and installation part.

Answers :

where is the PCV valve located
what would cause the car to run great untill you turn it off then jerks & kills
Where is the MAP sensor located, and how do I replace it? Any tricks?

You need a second opinion or clarification on your issue ? ask it in the comment box OR you can Ask Your Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

This content reflects information from various individuals and organizations and may offer alternative or opposing points of view.

2000 lesabre with 145,000 on it. check eng lite came on diag said map sensor on 2000 Buick LeSabre


replaced map sensor and light went off for 1 day. redid diagnostics and said low flow map sensor. after 1 month took sensor back and put anothe new one on. again light went off for 1 day and now back on. car started backfireing, jerking. in idle will ...

Where is the MAP Sensor located.? on 1996 Buick LeSabre


Are there any precautions in replacing it? The actual removal and installation part. ...

What should the voltages read on a 2000 Buick Lesabre MAF sensor plug? on 2000 Buick LeSabre


I read 5 volts on one and 13 on another I presume those to be right and the third wire must go to the ECM? ...

2000 buick lesabre test read po102 mass air flow sensor or vaf low input on 2000 Buick LeSabre


i hear a sucking sound for 30 sec or more when its cold it stops then i can drive off. when i stop at a light the RPMs raise up like im about to take off. sometimes it ideal down. ...

Would these sensors actually cause your brakes to stop working? on 1990 Buick LeSabre


My mom had a 1988 Buick LeSabre and she has to usually (but not always) press the brake pedal to the floor to get her brakes to work. She managed to get the car to the shop and after evaluation, the shop determined that her brakes were fine, no leaki ...

where is the fuel tank pressure sensore located . on my 99 buick on 1999 Buick LeSabre


show me a diograim of an where the fuel pressure sensore is located on my 99 buik ...

oil level sensor replacement on 1996 Buick LeSabre


My girlfriend is getting a Buick LeSabre for free from some family and it needs a oil level sensor among other things. How in depth is the replacement of that on this for a guy with common mechanics tools, nothing fancy like hoists or lifts or anythi ...

How to replace a pcv valve on a 2001 buick lasabre custom on 2001 Buick LeSabre


The pcv valve may be located below the MAP sensor but the electrical connector & the MAP sensor seem stuck. I do not want to break them. Should I force it? Am I in the right place for a 2001 buick lasabre? How do I replace the pvc valve?Thank you ...

Where can I find a mass air flow sensor for my 2000 Buick LeAve? on 2000 Buick LeSabre


The car will start but shut off ehrn RPM goes under 3,000. ...

despite replacing cam crank sensor(correct air gap) icm and ecm no spark. good ground to coil pack12 and 5 volts to each side of sensor connection. center has good ground. still no spark. what am I missing? on 1990 Buick LeSabre


also changed timing chain aligned correct marks. checked balancer for bad fins. I'm running out of places to look. connectors have no bent pins. all above have been re and rechecked. ...

Lesabre stalls sporadically, starts right back up. on 1995 Buick LeSabre


Have replaced crank sensor, harmonic balancer, MAF sensor, 02 sensor, fuel regulator, and tested IAC and MAP sensors. Fuel pressures are all good. New fuel filter, air cleaner and spark plugs as well. Removed entire throttle body and completely clea ...

1994 buick lesabre will not start, burps through intake manifold on 1994 Buick LeSabre


1994 buick lesabre 3.8 V6 misfires through intake manifold. I replaced the harmonic balancer, timing chain, spark plugs, crank shaft position sensor, repaired wiring to cam shaft sensor and crank shaft sensor. What could be the possible solution to t ...

crank sensor on 1998 Buick LeSabre


how to put on crank sensor and where is it located ...

crankshaft sensor on 1995 Buick LeSabre


In changing the sensor could I be refreshed on the steps that are need to be taken? ...

Tachometer occasionally drops to 0 and car makes strange grinding noise. Why? on 2005 Buick LeSabre


Car still running and speed doesn't change when tach drops to 0, but acceleration also seems to be compromised. Turning car off and back on usually stops this for awhile. Does shifting depend on tach reading? Am I doing damage to something by con ...

code po303...what would I expect the o2 sensor to read if an injector is leaking on 1999 Buick LeSabre


the reader picks up a po303 only after a long period of idling.the first o2 sensor reads .1 to .7. ...

I would like a visual of the throttle position sensor on 1997 Buick LeSabre


I need to see where the sensor can be found under the hood ...

Where is the mass air flow/Crankshaft position sensor. on 2003 Buick LeSabre


What tools are needed to replace it? What is the diagnostic code? ...

Car stalls won't start cam sensor replaced what else could it be? on 1993 Buick LeSabre


Car stalls and won't start,we changed cam sensor,neutral safety switch,coils,and catalytic converter, and it still stalls,what else could it be. ...

A detailed question is important to get you a relevant answer .

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || cheapestukipodrepairs.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1219 seconds