Estimate to replace an O-ring for the #2 cylinder. on 1997 Ford Contour

Just bought the car took to advance auto they say needs repair on this O-ring.

Answers :

O-ring for #2 cylinder needs to b replaced

You need a second opinion or clarification on your issue ? ask it in the comment box OR you can Ask Your Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

This content reflects information from various individuals and organizations and may offer alternative or opposing points of view.

Estimate to replace an O-ring for the #2 cylinder. on 1997 Ford Contour


Just bought the car took to advance auto they say needs repair on this O-ring. ...

O-ring for #2 cylinder needs to b replaced on 1997 Ford Contour


I need an estimate for the replacement of an O-ring for the #2 cylinder. Want to be sure I don't get ripped off when it is replaced. Thank you for any information you can help me with. ...

estimate to replace cylinder head temp sensor & evaporate vent solenoid on 2002 Ford Mustang


Check engine diagnose found following DTC:P1285 cylinder head over temp condition (sensor). P1450 unable to bleed up fuel tank vacuum, P1299 cylinder head over temp protection active. Further test found cylinder head temp sensor reading up to 60 deg. ...

Can front ABS ring be replaced without replacing entire Halfshaft? on 2001 Ford Escape


Can front ABS Ring be replaced without replacing entire halfshaft and estimate cost for repairCan you supply step-by-step instructions? ...

why is my #3 cylinder misfiring after replacement parts on 1999 Ford F-150


i replaced the plug, plug wire, and the coil pack and i still am getting a misfiring problem i have hooked it to the computer at the local shop and its stating it is the 3rd cylinder that is misfiring will someone help me i neeed to get this addresse ...

sparkplug blew out on no. 3 cylinder. What are repair options and estimates on 2001 Ford E-250


are these the options:1>new insert without removing head but "gluing"2. new insert removing head for better access and fix3> replace the head4 replace the engine ...

How to replace 1st cylinder coil on a 2003 Ford E350 XLT Super Duty Van? on 2003 Ford E-350


My van has a 1st cylinder misfire.It needs the coil replaced.I purchased the coil.I need instructions and helpful tips to install it myself please. Thank You! ...

I have a cylinder 2 and cylinder 5 misfire, replaced coil pack, wires and plugs. on 1997 Ford Explorer


The idle is rough, but smooths out and runs fine while driving. O2 sensors have been replaced also. ...

when replacing water pump what other parts should i replace? and estimated cost on 2000 Ford Explorer


water pump is leaking. what other parts will i need and estimated cost of repairs ...

How easy or affordable is it to replace two cylinders? on 2002 Ford Escape


We paid a mechanic to replace the spark plugs & cylinders as well as the spark plug tube seals since oil was present around spark plug. He only replaced the plugs & let us drive off with two of them misfiring. We broke down on the freeway. No ...

how many hours does it take to replace master cylinder? on 1998 Ford Escort


To replace the master cylinder on a 1998 ford escort? ...

what causes the cylinders to need to be replaced? on 2002 Ford Thunderbird


Car has 25k miles and I just replaced all spark plugs as engine light was on. Engine light is back on and my mechanic says 2 cylinders need replacement and the other 6 will likely need replacement soon. ...

Do I need to replace a coil or a cylinder? How much would either cost? on 2002 Ford Escape


Think mechanic said cylinder had to be replaced after replacing spark plug does not remedy problem, but did he say coil? How much does it cost to repair coil? Cylinder? ...

how do you replace thermastat in a 2000 2.5 v contour on 2000 Ford Contour


over heats in just a few mins of cranking pictures would be great too im no machanic l.o.l ...

the fans wewe not working replaced them,replaced radiatior,waterpump,fuse, sens on 1995 Ford Contour


where should temp gauge read,says (normal) reads between a-l on gauge is this saying ity is to hot?and should my fan be running?it is winter here ...

replaced master brake cylinder bled system still have no brake pressure. Why? on 2010 Ford Fusion


2010 Ford fusion s . Brake master cylinder was leaking I removed it and found that the main gasket had given out. I bought a brand new master cylinder and bled the system I still have no brake pressure . What could be wrong. There are no visible leak ...

How much would it cost or what's an estimated cost to replace servo bands? on 2004 Ford Explorer


What's an estimated cost to replace the intermediate servo band or all the bands? I saw on one website it's around $199 per part but what's an estimate for parts and labor? It knocks/jerks real hard at 2nd gear.. ...

A detailed question is important to get you a relevant answer .

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || cheapestukipodrepairs.com || Terms of Use || Contact || Privacy Policy
Load time: 0.2130 seconds